Tri-Glo LED Fog Light KitFOR THE 2021–2026 Ford Bronco

Choose a targeted Bronco lighting upgrade with this tri-glo led fog light kit. This kit is built around the factory Modular bumper, so the bumper and control wiring matter as much as the model year.

Six independently adjustable projector lights

Tri-Glo uses six projector lights across the two bumper assemblies. Each can be adjusted separately, which makes careful aiming part of the installation. The harness connects at the battery and relay, and the light assemblies use the factory bumper Torx bolts without splicing the vehicle harness.

Check the bumper before choosing fog lights

Ford offered more than one front bumper on the Bronco, and fog-light mounting locations are not interchangeable by default. This application is tied to the factory Modular steel bumper. Confirm that the vehicle still has that bumper and the required mounting locations before ordering. A similar-looking aftermarket bumper or a different factory bumper is not a verified substitute. The bumper requirement remains important even when the model year is in range.

Plan the switch and wiring route

Read the wiring arrangement for this exact kit before removing the original parts. Some assemblies use a T-harness, while others connect to auxiliary switches or use a battery-and-relay harness. Those methods should not be treated as interchangeable. Route cables away from sharp bumper edges and moving components, and leave enough protected slack at each connection. Use the supplied instructions for power, grounding, and circuit protection rather than selecting a fuse or wire size by guesswork.

Set the beam after the lamps are mounted

Secure both assemblies before adjusting the light direction. Aim the lamps for their intended use and check their operation from the actual switch arrangement you installed. A weather-sealed housing still depends on correct connector placement and careful wiring. Do not infer a lumen figure, beam distance, or road-use certification from the number of visible LEDs. Where a specific certification is listed for this part, it is identified separately in the specifications.

Bronco fitment and equipment requirements

The verified application is 2021-2026 Ford Bronco, both two-door and four-door models. Requires factory Modular steel front bumper. Verify wiring and control method before installation. Bronco Raptor compatibility has not been verified for this part number. Does not fit Bronco Sport. Model-year coverage is limited to the listed application; it is not extended to a later year because the body looks similar. Check the actual equipment installed on the vehicle if a previous owner has changed it.

Installation planning

The listed installation method is bolt-on + wiring. The supplier estimate is about 1 hour. Treat a time estimate as a planning guide, not a promise for every vehicle. Lay out the supplied pieces, review the instructions for this exact SKU, and check the original mounting area before starting. Allow extra time if other accessories need to be moved or if the vehicle has already been modified.

Key specifications

• Tri-Glo Bumper Mounted LED Fog Light Kit
• High Intensity White LEDs
• Clear Polycarbonate Lenses
• Black Aluminum Housings
• Driver and Passenger Side Included

Includes

• (1) LH Light Assembly
• (1) RH Light Assembly
• (1) Wiring Harness
• (10) Cable Ties
• (2) M6 x 15mm Bolts
• (3) M6 Flange Nuts

Warranty coverage

Three years for manufacturing defects and one year for condensation defects. The manufacturer terms apply to the original retail purchaser and include conditions and exclusions. This limited warranty does not mean every type of damage is covered. Retain the purchase record and installation information; wear, installation damage, misuse, and changes to the part can affect eligibility. The stated coverage follows the current manufacturer terms for purchases after September 1, 2026.