SpeedForm Throttle Response ControllerFOR THE 2021–2026 Ford Bronco

Choose a different pedal feel with this SpeedForm controller. Adjust accelerator sensitivity through a connector-based controller rather than an engine calibration.

Five pedal-response modes with nine sensitivity levels

SpeedForm changes the relationship between accelerator-pedal input and throttle request. It offers Stock, Eco, Comfort/Sport, Sport, and Race modes with nine sensitivity levels. It does not establish a horsepower gain, replace an engine tune, or guarantee better fuel mileage.

Pedal response is different from engine power

An electronic pedal controller changes how accelerator movement is translated into a throttle request. A more sensitive setting can make the vehicle feel more eager with less pedal movement, but that is not evidence of an increase in maximum engine output. Choose this part to adjust pedal feel. It is not an engine calibration, transmission tune, or a solution for a vehicle with a mechanical or diagnostic fault.

Choose sensitivity for the situation

Begin with the factory-style setting and learn what each adjustment changes before selecting a more aggressive response. A setting that feels useful on a road may be less suitable where careful low-speed pedal control matters. The available modes give you a range of response choices rather than a single fixed behavior. Make changes while safely parked and follow the controller instructions instead of experimenting with menus while driving.

Protect the pedal connection during installation

The controller connects at the original accelerator-pedal harness. Make sure the connection is secure and route the module cable so it cannot interfere with pedal travel, shoes, or floor mats. Follow the prescribed power-off and startup procedure. After installation, verify normal pedal operation before regular driving. A reversible connector-based installation does not establish a blanket promise about vehicle warranty coverage or the absence of diagnostic codes.

Bronco fitment and equipment requirements

The verified application is 2021-2026 Ford Bronco, both two-door and four-door models. Plugs into the factory accelerator pedal connector; verify connector before use. Bronco Raptor compatibility has not been verified for this part number. Does not fit Bronco Sport. Model-year coverage is limited to the listed application; it is not extended to a later year because the body looks similar. Check the actual equipment installed on the vehicle if a previous owner has changed it.

Installation planning

The listed installation method is plug-in. The supplier estimate is about 15 minutes. Treat a time estimate as a planning guide, not a promise for every vehicle. Lay out the supplied pieces, review the instructions for this exact SKU, and check the original mounting area before starting. Allow extra time if other accessories need to be moved or if the vehicle has already been modified.

Key specifications

• Eliminates Drive-By-Wire Pedal Delay
• Enhances Vehicle Acceleration
• Stock, Eco, Sport/Comfort, Sport, and Race Modes
• Nine Positions of Sensitivity Adjustment
• Easy Plug-and-Play Installation

Includes

• (1) Throttle Controller

Warranty coverage

Three years for manufacturing defects under the Raxiom limited warranty. The manufacturer terms apply to the original retail purchaser and include conditions and exclusions. This limited warranty does not mean every type of damage is covered. Retain the purchase record and installation information; wear, installation damage, misuse, and changes to the part can affect eligibility. The stated coverage follows the current manufacturer terms for purchases after September 1, 2026.