Bomber Front Bumper (Rigid)FOR THE 2021–2027 Ford Bronco

Will This Bumper Fit My Bronco?

The Addictive Desert Designs Bomber Ford Bronco front bumper, part number F230194130103, is listed by ADD for 2021–2026 Ford Bronco models. This is the standard-Bronco version. Confirm any Raptor application separately rather than treating a general Bronco listing as proof of fitment. ADD's current listing ends at 2026, so confirm 2027 compatibility before ordering. Check aftermarket equipment separately from statements about factory components.

Who Is This Bumper Best For?

This Bronco Bomber is the Rigid lighting version. Choose it if you have settled on Rigid 360 lamps and want their dedicated center layout in a close-fitting plate bumper. The other Bomber lighting version uses different center mounts, so select by the lamps you actually intend to run.

How Is This Bumper Built?

The plate-steel bumper follows the Bronco's body lines with a low-profile shape. Hammer black powder coat covers the steel and satin black finishes the aluminum panels. Those panels frame the lights and distinguish the Bomber's face from a universal light-bar bumper.

Dedicated Rigid 360 Light Mounts

The center panel frames mounting positions for three 6-inch Rigid 360 round lights. These are light-specific provisions, not a promise that any round lamp of similar diameter fits. Check the lamp model before ordering, especially if transferring lights from a previous build or comparing the two Bomber versions.

Which Lights Fit This Bumper?

Two additional cube-light positions sit at the sides. This lets your Bronco use the center round lights alongside separate side illumination. Lights and their harnesses are purchased separately. Decide how the lamps will be switched and where the wiring will run before installing the bumper.

What Factory Equipment Does This Bumper Retain?

The factory parking sensors are retained. ADD's current listing specifies reinforced clevis mounts for soft shackles. It lists the OEM skid as reusable with trimming, with a matching 3/16-inch vented aluminum skid available separately. Plan the separate ACC relocation bracket for an equipped Bronco rather than assuming parking-sensor retention covers ACC.

Choosing the Complete Lighting Setup

Compare the complete installed setup, not just the bumper's light openings. A light mount does not include the lamp, switch, harness, or connectors. Choose the beam pattern for your intended use and check the housing depth and bracket width before purchase. Plan how the wiring will reach the mounting position without being pinched during assembly. If you already own lights, identify their exact models first; similar nominal sizes can use different housings and mounting brackets.

How Does This Bumper Install?

The bumper uses bolt-on mounts, and ADD's guide estimates about 2 hours for removal and bumper installation. Allow additional time for wiring, sensor transfer, and relocation accessories. Arrange assistance for supporting the original bumper and positioning the replacement.

Read the Bomber front bumper installation guide before starting. Match it to SKU F230194130103, check the hardware inventory, and identify the original parts to reuse. Bolt-on mounting does not make every configuration trimming-free or wiring-free; follow the steps for your actual equipment.

What's Included?

The Rigid Bomber package provides the bumper assembly, aluminum panels, center and side light mounts, and installation provisions. The optional full aluminum skid is separate from the bumper. Lamps, recovery gear, wiring, and electronics relocation equipment are separate purchases.

What's the Warranty?

ADD provides a one-year limited warranty against defects in materials and workmanship from the original purchase date. The manufacturer's terms exclude installation, labor, normal wear, misuse, and collision damage. Keep your purchase record and review the full terms for coverage and claim requirements.