LED Fog LightsFOR THE 2021–2026 Ford Bronco

Add a white fog-light or amber running-light function in the factory Modular bumper openings. This pair keeps both sides matched and uses the original bumper mounting hardware. Decide on the wiring arrangement before fitting the lights so the controls work as intended.

White and amber functions with different wiring paths

With factory auxiliary switches, the supplied splice block supports the chosen light functions but white and amber cannot run at the same time. Without those switches, the instructions call for splicing the selected harness wire into the headlight wiring. This distinction matters more than a simple plug-and-play label.

Check the bumper before choosing fog lights

Ford offered more than one front bumper on the Bronco, and fog-light mounting locations are not interchangeable by default. This application is tied to the factory Modular steel bumper. Confirm that the vehicle still has that bumper and the required mounting locations before ordering. A similar-looking aftermarket bumper or a different factory bumper is not a verified substitute. The bumper requirement remains important even when the model year is in range.

Plan the switch and wiring route

Read the wiring arrangement for this exact kit before removing the original parts. Some assemblies use a T-harness, while others connect to auxiliary switches or use a battery-and-relay harness. Those methods should not be treated as interchangeable. Route cables away from sharp bumper edges and moving components, and leave enough protected slack at each connection. Use the supplied instructions for power, grounding, and circuit protection rather than selecting a fuse or wire size by guesswork.

Set the beam after the lamps are mounted

Secure both assemblies before adjusting the light direction. Aim the lamps for their intended use and check their operation from the actual switch arrangement you installed. A weather-sealed housing still depends on correct connector placement and careful wiring. Do not infer a lumen figure, beam distance, or road-use certification from the number of visible LEDs. Where a specific certification is listed for this part, it is identified separately in the specifications.

Bronco fitment and equipment requirements

The verified application is 2021-2026 Ford Bronco, both two-door and four-door models. Requires factory Modular front bumper. Explicitly excludes Raptor. Wiring differs with factory auxiliary switches. Does not fit Bronco Raptor. Does not fit Bronco Sport. Model-year coverage is limited to the listed application; it is not extended to a later year because the body looks similar. Check the actual equipment installed on the vehicle if a previous owner has changed it.

Installation planning

The listed installation method is bolt-on + wiring. The supplier estimate is about 2 hours. Treat a time estimate as a planning guide, not a promise for every vehicle. Lay out the supplied pieces, review the instructions for this exact SKU, and check the original mounting area before starting. Allow extra time if other accessories need to be moved or if the vehicle has already been modified.

Key specifications

• Can Function as Amber Running Lights or White Fog Lights
• Enhanced Brightness Over OEM for Better Visibility
• Clear Polycarbonate Lenses
• Black ABS Plastic Housings
• Plug and Play Installation
• Sold as a Pair, Driver and Passenger Side Included

Includes

• (1) LH Fog Light
• (1) RH Fog Light
• (2) Y Harnesses
• (1) Wiring Harness
• (1) Splice Block

Warranty coverage

Three years for manufacturing defects and one year for condensation defects. The manufacturer terms apply to the original retail purchaser and include conditions and exclusions. This limited warranty does not mean every type of damage is covered. Retain the purchase record and installation information; wear, installation damage, misuse, and changes to the part can affect eligibility. The stated coverage follows the current manufacturer terms for purchases after September 1, 2026.