Fitment

Morimoto builds this fog light bracket and wiring kit for the 2021 Ford Bronco, the 2022 Ford Bronco, the 2023 Ford Bronco, the 2024 Ford Bronco, the 2025 Ford Bronco, and the 2026 Ford Bronco. The brackets bolt to the factory A-pillar mounting points near the windshield, a location built into the frame on every trim and every bumper style. No drilling, cutting, or trim modification is needed anywhere in the install. The fit stays the same across two-door and four-door body styles and across soft top and hard top setups, since the mounting point sits on the A-pillar itself rather than on the roof or the bumper.

Design and What's Included

The kit centers on Morimoto's own A-pillar bracket pair, matte black powdercoated stainless steel built to handle sun, mud, and road grime without flaking or rusting. Alongside the brackets, the kit adds a complete plug and play wiring harness: two triple sealed 40 amp M-spec relays, a normally off M-spec switch with an amber backlight, six DT06 two pin outputs, twelve gauge insulated copper output wiring, and ten gauge insulated copper input wiring with ring terminals for the battery connection. Each output can carry up to five amps, enough headroom for a wide range of auxiliary lighting setups. A full stainless steel hardware pack and a limited lifetime warranty from Morimoto round out the package. This kit does not include fog light pods. It is built for a Bronco owner who already has a set of 4Banger pods on hand, or who plans to pick pods separately and wants the mounting and wiring side handled in one box.

Street Legality

Photometrics on this kit's wide beam pattern meet the SAE F 20 standard, which covers legal fog lamp use on public roads when the pods are aimed correctly. That SAE F 20 rating and DOT compliance apply to the wide beam configuration this kit is designed around, so a Bronco owner planning to run fog lights on the street has a documented standard to point to.

Installation

Installation uses the factory A-pillar mounting points, so the bracket side of the job stays modification-free with basic hand tools. The relay and harness side routes into the engine bay, with the twelve gauge output wiring running out to each pod and the ten gauge input wiring landing on the battery through the included ring terminals. The amber backlit switch mounts in the cab for easy on-off control. At about 8 pounds packaged, this kit carries more heft than a brackets-only listing because of the relay pair and full harness included. Bronco Forge ships this kit with Morimoto's printed install guide plus a downloadable PDF for reference during the job.

Compatibility

These brackets and harness are matched to Morimoto's own 2Banger and 4Banger pod lineup, with the harness outputs and relay capacity sized around that pod family's power draw. A Bronco owner who already owns 4Banger pods from a separate purchase can wire straight into this kit without buying pods again. A Bronco owner who only needs the brackets, with pods and wiring already sorted from another source, can look at Morimoto's brackets-only version instead and skip the relay and harness pieces entirely.

These parts are manufactured in China to Morimoto's own engineering specifications.