Console Molle PanelsFOR THE 2021–2026 Ford Bronco

Fitment

These center console molle panels are built by Addictive Desert Designs for the 2021, 2022, 2023, 2024, 2025, and 2026 Ford Bronco and Bronco Raptor, across all trims. The kit includes a driver-side and a passenger-side panel, both shaped to sit alongside the factory center console without interfering with the controls mounted there. Because the console layout is shared across the Bronco lineup, the fitment covers everything from a base trim two-door up through a fully equipped Raptor.

Design

Each panel is cut from 1/8-inch steel and finished in a hammer black powder coat, and each carries a row of eight PEM nuts along the top edge sized for 10-24 accessory bolts. Those PEM nuts are what makes the panels compatible with RAM Mounts hardware, so a phone cradle, tablet mount, or two-way radio mount can be bolted directly to the panel rather than clamped to the console edge or stuck on with an adhesive mount that eventually works loose over time.

Storage and Access

Beyond the RAM Mount compatibility, the molle pattern across each panel accepts straps, bolts, or clips for mounting pouches, holsters, or other small gear directly to the side of the console instead of leaving it loose on the seat or in the door pocket. The kit is built as a two-panel, driver-and-passenger set specifically so both sides of the console gain usable mounting space rather than leaving just one side equipped. The passenger-side grab handle stays fully usable with the panel installed, and none of the factory controls on either side of the console lose accessibility once the panels are in place.

Why the Console

The center console sits closer to the driver than the dash or the overhead area, which makes it a natural spot for anything that needs to be reached while the truck is moving, like a phone showing a map or a handheld radio. Most factory Broncos leave that space with nowhere to permanently mount a device beyond the cup holders, so a driver ends up wedging a phone against the console or holding a radio in one hand instead of running it hands-free. Bolting a device mount directly to a PEM nut on one of these panels solves that without relying on suction cups or friction mounts that shift around on rough roads.

Installation

Installation requires some minor drilling to secure the panels in place but does not require removing the dash or the console itself, so the job stays contained to the console area rather than turning into a full interior teardown. Bronco Forge stocks this Addictive Desert Designs molle panel set for Bronco and Bronco Raptor owners who want a mounting point for digital devices and gear at the console without giving up access to the factory controls, the grab handle, or the console itself. Because the same panel design fits both the standard Bronco and the Raptor, the kit stays usable if an owner later moves from one trim to another within the same generation of truck.